The “Poison Dart Frog” Challenge; The Ring Flash (And A Little Bit O’ Photoshop) Solution

I recently had the opportunity to photograph poison dart frogs, and I was excited to do so because these unique creatures have brilliant colors and are endlessly fascinating. While they make for amazing pictures, they also present significant technical challenges. I had to do some thoughtful planning before I attempted to shoot them. I started out by buying several tropical plants and flowers at a nursery to use as props, then sat down to consider the technical issues.

Dendrobates Auratus From Panama
Canon EOS-1Ds Mark II, ring flash set to lighting ratio 3:1, 50mm macro, f/32, Manual Exposure mode.
All Photos © 2008, Jim Zuckerman, All Rights Reserved

First, dart frogs are very small-- much smaller, in fact, than you would think. One of the frogs I photographed in particular was the size of a dime; others were not more than an inch and a quarter long. This meant that depth of field would be extremely critical. Since macro photography is all about seeing and appreciating the intricate and fascinating details in tiny subjects, middle-of-the-road lens apertures like f/8 and f/11 wouldn't do. I needed to use the smallest lens aperture possible, which is f/32 on my 50mm macro.

This meant, of course, that available light photography was out of the question. A small lens aperture would force the shutter speed to be too slow for wildlife photography. I had to use flash, therefore, and the flash had to be placed close enough to the frogs so the light output was sufficient to give me a good exposure at f/32 with a low ISO for maximum picture quality and a minimum of digital noise.

Second, the frogs are shiny. Whether they are wet or dry, their skin readily reflects any bright light source. This presents an insurmountable problem because when a reflective surface is flat we can angle the camera to avoid the reflection. However, when the surface of the subject is contoured, it reflects light in many directions and it's not feasible to avoid it.

Dendrobates Tinctorius From Surinam
Canon EOS-1Ds Mark II, ring flash set to lighting ratio 1:1, 50mm macro, f/32, Manual Exposure mode.

Third, frogs are constantly jumping away from the camera lens. They instinctively want to find protective foliage, and it's hard to get them to sit still for more than a few seconds. Some subjects will settle down after a while, but most are very active and uncooperative. This means that one or two strobes in fixed positions are not necessarily the best setup because it will probably be necessary to follow the tiny subjects as they move from one flower or leaf to another. With a fixed lighting setup, when a frog jumps a few inches toward one of the flashes, that changes the flash-to-subject distance, which in turn changes the exposure.

Finally, a flash placed on the hot shoe of a camera would be too high to properly illuminate the tiny frogs. The light would pass right over them. Even if the light spread was such that the top part of the amphibians were lit well, the undersides would be unacceptably dark.

Enter The Ring Flash
I felt that the solution to all of these issues (except the problem of reflectivity) was to use a ring flash. Therefore, I bought Canon's MR-14EX ring flash. I had never owned a ring flash until recently because the original ring flash units consisted of a single light that produced a flat, dimensionless image. I always felt that the light was just too flat. Canon's MR-14EX ring flash, however, has two small, controllable flash units inside the ring that can be operated independently of each other. I can turn one of the lights off and use only one off-axis light source, or both can be used where I define the lighting ratio between the two light sources. In addition, the ring light can be rotated around the lens so the two lights can be positioned on either side, left and right, or top and bottom--or anywhere in between. The ring itself attaches to a macro lens with a small flange which screws into the lens like a filter.

Ratios And Total Output
Lighting ratios are typically used in studio work where photographers compare the light output of the main light with the fill light, and it's measured with a handheld flash meter. Understanding ratios can be confusing because there are two ways to make the calculation. For example, if the exposure for the main light is f/8 and the exposure for the fill light is f/5.6 (this would be determined by a handheld flash meter), the ratio is understood to be 2:1. This means that the main light provides double the amount of light that the fill does. However, that doesn't take into account the combined light output that occurs when the picture is taken with both lights. If we say that the main light puts out two units of light and the fill light contributes one unit (this makes sense in a 2:1 ratio), the combined output is three units. So, the ratio of the total light on the scene to the fill is really 3:1, e.g., three units of light compared to one unit of light. A 4:1 ratio is a two f/stop difference in light output, such as f/8 from the main light and f/4 from the fill. However, if we calculate the total flash output the 4:1 ratio becomes 5:1.

Dendrobates Pumilio From Panama
This frog is the size of a dime. (Canon EOS-1Ds Mark II, ring flash set to lighting ratio 1:1, 50mm macro, f/32, Manual Exposure mode.)

Whatever number we assign to the ratio, Canon's ring flash allows you to change the lighting ratio between the left and the right lights (or the top and bottom lights, depending on how you rotate the ring around the lens). This gives us the ability to have dimension and depth in macro photographs plus the mobility to follow a subject that just can't sit still.

I want to point out that if you have a 100mm or 180mm macro lens, this increases the working distance between the camera and the subject. As the camera moves farther away from the subject, the ring flash will act as a single light source rather than a ring of light that surrounds the subject. This is especially noteworthy because the lighting ratio become ineffectual when the ring flash acts as a single source of light. This is why I photographed the frogs with a 50mm macro and not one of the others. When the ring is right on top of the subject, the lighting ratio helps make the images look beautifully lit.

ARTICLE CONTENTS

X